4 hand torch switch replacement – Tweco PAK 15XC User Manual
Page 72
Advertising
CUSTOMER/OPERATOR SERVICE
68
Manual 0-2251
5.4 HAND TORCH SWITCH REPLACEMENT
Hand Torch Head
Replacement
WARNING
Disconnect primary power to the system before
disassembling the torch, leads, or power supply.
Refer to Figure 5-C and:
1. Roll the sheath up over the torch handle to expose the
torch switch connectors and the torch switch.
2. Remove the tape from the two single-pin torch switch
connectors and disconnect the torch switch leads.
3. Replace the torch switch and connect the two torch
switch leads connectors.
4. Secure the torch switch leads in place with electrical
tape. Locate the tape over the two connectors.
5. Roll the torch switch sheath back over the handle to
cover the torch switch and connectors.
Advertising