Tweco PakMaster 75XL Plus (CE) - Manual (Page 16)

INTRODUCTION 2-2 Manual 0-2782
8. Pilot Circuitry
Capacitive Discharge (CD), Pulsed DC
9. Weight
71 lbs (32 kg) withwork lead, input power cable
78 lbs (35.4 kg) withwork lead, torch & lead, input power
cable
10. Overall Dimensions
19" (482 mm) High x 13" (330 mm) Wide x 24.8" (630
mm) Long
Overall dimensions are with Handle, Lead Wrap
Bracket, and Gas Regulator/Filter Assembly installed.
B. Gas Regulator/Filter Assembly
Specifications
The following specifications apply to the Gas Regulator/
Filter Assembly only:
1. Gas regulator maximum gauge pressure
160 psi (11 bar)
2. Maximum input gas pressure
125 psi (8.6 bar)
3. Filter
Coalescent type filter
2.04 Power Supply Options and
Accessories
The following accessories are available for this power
supply. Refer to Section 6, Parts Lists, for part numbers
and ordering information
A. Single Stage Air Line Filter Kit
A Single Stage In-Line Air Filter for use with com-
pressed air shop systems. Filters moisture and par-
ticulate matter from the air stream to at least 0.85 mi-
crons.
B. Two Stage Air Line Filter
A Two Stage In-Line Air Filter for use on compressed
air shop systems. Filters moisture and particulate mat-
ter from the air stream to at least 5.0 microns.
C. High Pressure Regulators
High pressure regulators are available for air and ni-
trogen. The regulators are used to set the proper pres-
sure for the type gas being used.
NOTE
Regulators should not be installed with options A
or B above.
D. Multi-Purpose Cart
Rugged steel cart on easy-rolling rear wheels and
front-mounted swivel casters. Provides maximum
mobility for the power supply and can also serve as a
display cart. Top shelf is 12 " (305 mm) x 20 (508 mm).
Steel handle is 30" (762 mm) high.
E. Computer Control Cable (CNC)
NOTE
This accessory can be used only with the PCM-60
Torches.
The interface cable is available in two lengths, 25 ft
(7.6 m) and 50 ft (15.2 m). The cable is used to inter-
face the power supply with an auxiliary control de-
vice to provide OK-To-Move and ON/OFF signals.
F. Remote Hand Pendant Control
The remote hand pendant control is available with a
20 ft. (6.1 m) cable. An extension cable of 25 ft. (7.6 m)
can be added to the standard hand pendant control to
produce a total length of 50 ft. (15.2 m).
G. Cutting Guide Kit
Easy add-on attachments to allow for straight line,
circle, or bevel cutting.
H. Standoff Cutting Guide
Simple, push-on guide attachment to allow for torch
dragging without risk of touching tip.