11 tip saver/drag cut sensing circuit – Tweco PakMaster 75XL Plus User Manual
Page 24
Advertising
SECTION 3: INSTALLATION PROCEDURES
18
Manual 0-2746
3.11 Tip Saver/Drag Cut Sensing
Circuit
This power supply is equipped with a Tip Saver/Drag
Cut Sensing Circuit which cuts current back to 35 amps if
the tip touches the workpiece. The purpose of this is to
prolong the life of the tip.
If the user does not want the current to be decreasedwhen
the tip touches the workpiece, the sensing circuit can be
defeated by closing switch SW1-1 on the Gate/Logic PC
Board. Slide top white toggle on SW1-1 to the right to
close circuit.
A-02569
Gate/Logic PC Board
SW1
1 2
ON
Figure - SW1 Switch Location
WARNING
Tip life will be considerably shortened if tip is re-
peatedly touched to the workpiece without the Tip
Saver/Drag Sensing Circuit feature active.
Advertising