Tweco 6045 Excel Arc User Manual
Excel arc, 6045 operating manual, Cc/cv power source
Advertising
Table of contents
Document Outline
- 6045 EXCEL ARC
- SECTION 1:ARC WELDING SAFETY INSTRUCTIONS AND WARNINGS
- SECTION 2: INTRODUCTION
- SECTION 3: INSTALLATION
- SECTION 4: OPERATION
- 4.01 Front Panel
- 4.02 Machine Set-Up and Operation
- 4.03 Adjustments Behind the Control Panel
- 4.04 Hot Start Switch Enable/Disable
- 4.05 SMAW (Stick) Welding & Carbon Arc Gouging
- 4.06 GTAW (TIG) Welding
- 4.07 GMAW / FCAW with Constant Speed Wire Feeder
- 4.08 GMAW / FCAW with Voltage Sensing Wire Feeder with Contactor
- SECTION 5: SERVICE
- 5.01 General
- 5.02 Maintenance
- 5.03 Maintenance Diagram
- 5.04 Basic Troubleshooting Guide
- 5.05 General Thermal Conditions
- 5.06 Operator Troubleshooting
- 5.07 Troubleshooting All Modes of Operation
- 5.08 Troubleshooting STICK (SMAW /CAG) Mode Problems
- 5.09 Troubleshooting TIG (GTAW) ModeProblems
- 5.10 Troubleshooting MIG (GMAW /FCAW) Mode Problems
- APPENDIX 1: WIRING SCHEMATICS
- LIMITED WARRANTY