Tweco 250 Weldskill MIG - Manual (Page 13)

2- Manual No 0-5072
INTRODUCTION welDskIll 250, 350
December , 2008
SECTION 2:
INTRODUCTION
2.01 How to Use This Manual
This Owner’s Manual usually applies to just the un-
derlined specification or part numbers listed on the
page 3. If none are underlined, they are all covered
by this manual.
To ensure safe operation, read the entire manual,
including the chapter on safety instructions and
warnings.
Throughout this manual, the word WARNING, CAU-
TION and NOTE may appear. Pay particular attention
to the information provided under these headings.
These special annotations are easily recognized as
follows:
!
WARNING
Gives information regarding possible per-
sonal injury. Warnings will be enclosed in
a box such as this.
CAUTION
Refers to possible equipment damage.
Cautions will be shown in bold type.
NOTE
Offers helpful information concerning
certain operating procedures. Notes will
be shown in italics.
2.02 Equipment Identification
The unit’s identification number (specification or part
number), model, and serial number usually appear on
a nameplate attached to the machine.
Equipment which does not have a nameplate attached
to the machine is identified only by the specification
or part number printed on the shipping container.
Record these numbers for future reference.
2.03 Receipt of Equipment
When you receive the equipment, check it against
the invoice to make sure it is complete and inspect
the equipment for possible damage due to shipping.
If there is any damage, notify the carrier immediately
to file a claim. Furnish complete information concern-
ing damage claims or shipping errors to the location
in your area listed in the inside back cover of this
manual.
Include all equipment identification numbers as
described above along with a full description of the
parts in error.
Move the equipment to the installation site before
uncrating the unit. Use care to avoid damaging the
equipment when suing bars, hammers, etc., to uncrate
the unit.