Tweco 250i Transmig Inverter - Manual (Page 36)

TRANSMIG 250i INSTALLATION/SETUP
INSTALLATION/SETUP 3-18 Manual 0-5187
3.11 Fitting of Optional Roll Cage
1. Assemble the Roll Cage according to Figure 3-11. Ensure that all hardware is properly tightened and will not
come apart with the power source attached.
NOTE
You will need to wait to attach the front roll bar until after the welder has been mounted.
Art # A-10336
These holes are not used
Note the orientation
of the 3 studs
Rear
Front
Do not attach front yet
Rear
Front
Figure 3-11: Roll Cage Assembly
2. Disconnect power from the power source.
3. Remove the top centre screw in the cover and open the side cover to the wire spool so you can see the 3 holes
that will need to align with the mounting studs from the roll cage.
4. Carefully lift the unit and maneuver into place aligning the 3 studs with the 3 holes in the bottom of the power
source.
3 Nuts
3 Studs
Art # A-10337
Front
2nd
1st
These holes are not used
Figure 3-12: Mounting Welder to Roll Cage.
5. First, use the 3 nuts (included) and secure the power source to the roll cage. Second, attach the front roll bar
and secure all hardware now. When you are done it should look like the first part of Figure 3-13.
6. Attach the Cross Bar to the front and rear roll bars with hardware shown and the bracket with the screw from
the top of the welder cover removed earlier. See Figure 3-13.