Tweco 250i Transmig Inverter - Manual (Page 37)

INSTALLATION/SETUP TRANSMIG 250i
Manual 0-5187 3-19 INSTALLATION/SETUP
Art # A-10325
Cross Bar
Figure 3-13: Roll Cage Cross Bar Fitted
3.12 Assembly and Fitting of Optional Welding Trolley
Assemble the Welding Trolley according to Figure 3-14. Read all steps before beginning and ensure all hardware is
tightened properly.
1. Attach the front base section to the upright rear section with the 3 screws provided.
NOTE
If attached, the optional roll cage must be removed before mounting to the Welding Trolley as the same
mounting holes are used for both.
Art # A-10326
4 screws
provided
3 screws
provided
Chain
Rubber Mat
Screw from top
of 250i
3 screws provided
to secure 250i
Figure 3-14: Welding Trolley Assembly
2. Mount the 250i power source to the bottom tray aligning the 3 holes in the bottom of the power source with
the 3 holes in the base. Secure with the 3 screws provided.