Tweco 400i Transmig - Manual (Page 32)

TRANSMIG 400 i
4-10 July 18, 2008
4.09 Sequence Of Operation
NOTE:
Parameter Buttons are used to select the parameters to be set. The LED's show which function is
being adjusted on the weld sequence graph. Refer to Symbols Table located in the front of the
manual for Symbol descriptions.
Art # A-08422
7
4
3
5 6
2
1
Figure 4-6: Transmig 400 i Front Panel
1. Contactor Function: Pressing this buttons enables Contactor functions. This function is operable in MIG
mode only. It is used to enable the output such that a voltage sensing wirefeeder i.e. Transmig VS 212 can
be connected.
2. Remote Functions: Pressing this buttons enables remote current functions.
3. Digital LED Displays: Welding amperage, Voltage and parameter values are displayed in this window.
Internal warnings such as over temperature, low or high input voltage applied are signaled to the operator
by a warning sound and error message on the screen.
4. Save/Load Buttons: By using the Save & Load buttons the operator can easily save up to 5 welding
parameter programs. The Save/Load buttons must be depressed for 3 seconds to store settings.
5. Control Knob: Allows the operator to adjust the output amperage/voltage within the entire range of the
power source, also used to set each parameter value.
6. Process Button: This button selects between STICK, Lift TIG, and MIG modes. MIG modes include MS for
mild steel and SS for stainless steel.
7. Parameter Button: This button select between HOT START, WELD CURRENT, and ARC CONTROL while in
STICK and Lift TIG modes and selects between WELD VOLTAGE and INDUCTANCE CONTROL while in MIG
mode. This button is also used in conjunction with the Save/Load buttons to save and load welding
programs.