Tweco FP-260 - Manual (Page 15)

ADDITIONAL SAFETY INFORMATION
Make sure you read and understand all of the information and instructions contained in this manual BEFORE
proceeding.
The National Electrical Code, Occupational Safety and Health Act (OSHA) regulations, local industrial codes
and local inspection requirements also provide a basis for equipment installation, use and service.
For additional information concerning welding safety, refer to the following standards and comply with them
as applicable.
• ANSI Standard Z49.1 - SAFETY IN WELDING AND CUTTING - obtainable from the American Welding
Society, 2051 N.W. 7th St. Miami, FL 33125 (305) 443-9353.
• ANSI Standard Z87.1 - SAFE PRACTICE FOR OCCUPATION AND EDUCATIONAL EYE AND FACE
PROTECTION - obtainable from the American National Standards Institute, 1430 Broadway, New York, NY
10018.
• NFPA Standard SIB - CUTTING AND WELDING PROCESSES - obtainable from the National Fire
Protection Association, 470 Atlantic Avenue, Boston, MA 02210.
• CGA Pamphlet P-I - SAFE HANDLING OF COMPRESSED GASSES IN CYLINDERS - obtainable from
the Compressed Gas Association, 5005th Avenue, New York, NY 10038.
• OSHA Standard 29 CFR, Part 1910, Subpart 0. - WELDING, CUTTING AND BRAZING - obtainable from
your state OSHA office.
• CSA Standard W117.2 - CODE FOR SAFETY IN WELDING AND CUTTING - obtainable from Canadian
Standards Association, 178 Rexdale Blvd., Rexdale, Ontario Canada M9W 1R3.
• American Welding Society Standard A6.0 - WELDING AND CUTTING CONTAINERS WHICH HAVE
HELD COMBUSTIBLES - obtainable from the American Welding Society, 2051 N.W. 7th St., Miami, FL
33125 (305) 443-9353.
13