Tweco FP-260 - Manual (Page 3)

INTRODUCTION
This User’s Guide provides specific information about your Firepower Welding System. This guide provides
pertinent information needed to safely and effectively use your Firepower Welding System. The information in
this manual applies to specific Firepower Welding System models. It gives instructions on set-up, installation
and actual use of your Firepower Welding System.
SAFETY PROFILE
Tradesmen respect the tools and equipment with which they work. They are also aware that tools and equip-
ment are dangerous if used improperly or abused.
Read this guide prior to using your welding system. It enables you to do a better and safer job. You will also
learn the machine’s application, limitations and the specific potential hazards related to welding.
SAFETY INFORMATION
The following safety information is provided to you as a guideline. Use it to operate your new Firepower
Welding System under the safest possible conditions. Any equipment that uses electrical power is potentially
dangerous to use when the safety or safe handling instructions are not known and/or are not followed. This
safety information gives you the necessary information for safe use and operation.
Items in this manual that significantly affect safety are identified with the following headings. Please read and
understand this manual. Pay special attention to items identified with these headings.
- Means there is a possibility of injury or death to yourself or others if the proper
safety precautions are not followed.
- Means there is the possibility of damage to the Firepower Welding System or
other property.
- Indicates points of interest for more efficient and convenient installation or opera-
tion. It may be used before or after a procedure to highlight or better explain the step.
READ ALL SAFETY AND WARNING INSTRUCTIONS CAREFULLY before attempting to install, oper-
ate or service this welding unit. Your failure to comply with the instructions could result in personal injury
and/or property damage.
RETAIN THESE INSTRUCTIONS FOR YOUR FUTURE REFERENCE.
GENERAL WELDING SAFETY INSTRUCTIONS
LOCATION
Welding processes of any kind can be dangerous not only to the operator but to
any person situated near the equipment, if safety and operating rules are not strictly
observed.
PERSONAL PROTECTION
1. Wear closed, non-flammable protective clothing, without pockets or turned up trousers.
2. Wear a non-flammable welding helmet to shield the neck, face and sides of the head. Keep the protective
lens clean. Replace the protective lens if broken or cracked. Position a transparent glass between the lens and
the welding area. Weld in a closed area that does not open into other working areas.