Tweco 7-3445 - Manual (Page 4)

Manual 0-2773 4 Installation Instructions 8/21/01
11. Install the proper torch consumables for the Power Supply amperage.
12. Connect the torch to the Power Supply.
13. Reconnect main input power to the Power Supply and turn the unit ON.
14. Set air pressure to 60 - 70 psi (4.1 - 4.8 bar).
15. Test torch for proper operation.
Torch Control Cable Wiring Diagram For Mechanized Systems
Torch Control
Connectors
Torch Lead Assembly
A-02571
Control Connector
Wiring & Plugs With
Signal Pin Connector
Part of
Quick Disconnect
To Torch
Control Device
Torch Control
Cable
NOTE
Every effort has been made to provide complete and accurate information in this manual. However, the
publisher does not assume and hereby disclaims any liability to any party for any loss or damage caused
by errors or omissions in this manual, whether such errors result from negligence, accident or any other
cause.