Tweco 9-9408 - Manual

April 6, 2006 1 Manual 0-4763 Rev. AA
Application
This product is for use only with Thermal Dynamics Gas
Control Module GCM-2010. Do not use this product with
any other equipment.
Unpacking
The product is packaged and protected to prevent damage
during shipping. Inspect for possible shipping damage.
If damage is evident, contact your distributor and/or ship-
ping company before proceeding with installation.
Contents
• PC Board Assembly, including:
Display PC Board and
Interface PC Board with connecting ribbon cable
• 8 Plastic Standoffs
• 4 Plastic Nuts
• Static handling items and instructions
• PC Board Installation Instructions
Manual 0-4763
GCM-2010
Display and Interface PCB Kit
Catalog# 9-9408
Installation Instructions
© 2005 by Thermal Dynamics Corp., Printed in USA
82 Benning Street, West Lebanon, NH 03784 USA
(603) 298-5711 • www.thermal-dynamics.com
Procedure
WARNING
Disconnect primary input power at the source and
bleed down the system before starting this proce-
dure.
1. Remove the cover from the Gas Control Module. A
ground wire connects the cover to the module. Do
not disconnect this wire.
Art # A-07062
CO MM
J57
J56
INP UTS
TVA
PO WER
SU PPL Y
H35
F5
AIR
N 2 O 2
Gas Control Module Cover
Do not remove
SHIE
LD
PLA SMA
PREFL
OW
H 2 O
SHIELD
H 2 O
CAUTION
Follow the static handling directions provided sepa-
rately.