Preparation, Fiber optic cable installation, Gas control module cover do not remove – Tweco 7-4000 User Manual
Page 2
January 4, 2006
2
Manual 0-4739
Preparation
1. Remove the screws securing the cover panel to
the Module.
2. Remove the Cover from the Module.
Art # A-07062
CO
MM
J57
J56
INPUTS
TVA
PO
WER
SUPPL
Y
H35
F5
AIR
N
2
O
2
Gas Control Module Cover
Do not remove
SHIELD
PLASMA
PREFL
OW
H
2
O
SHIELD
H
2
O
Fiber Optic Cable Installation
1. Remove the securing nut from the through-hole
protector supplied on the cable. Pass the cable
and the through-hole protector into the hole in
the connection panel on the back of the mod-
ule. Fasten the through-hole protector in place
with the securing nut. Do not tighten the pro-
tector.
2. Pass the fiber-optic connector through the hole
in the connection panel. Pass enough of the
cable into the Module to let the cable loop up-
ward as shown.
CAUTION
Avoid kinking, twisting, or bunching the fiber-
optic cable. The cable can be damaged by being
forced into tight-radius turns.