Tweco Victor Thermal Dynamics Interface Cable - Manual (Page 3)

Manual 0-5327 3
3- To use the interface cable simply insert the gold socket end of the interface cable into the gold header of the
PCB where the original harness was inserted then connect the original tin harness into the interface cable.
Repeat this procedure for the number of 2 pin or 5 pin connections on the replacement PCB.
NOTE:
In most 2 pin interface cable applications it is not required but recommended to place a wire tie in the
location shown below to increase the connect-ability of the harness. By adding this tied loop the harness
fits into the machine easier and puts less stress on most electrical connections. This is not recommended
for the 5 pin jumper.
NOTE
Every effort has been made to provide complete and accurate information in this manual. However,
the publisher does not assume and hereby disclaims any liability to any party for any loss or damage
caused by errors or omissions in this Manual, whether such errors result from negligence, accident, or
any other cause.