Tweco Welding Equipment Basic Utility Cart - Manual

WELDING EQUIPMENT basIc UTILITy caRT assEMbLy INsTRUcTIONs
0-5221 1 December 01, 2011
!
WARNING
Maximum Gas Cylinder 9" (230mm) Diam-
eter.
!
WARNING
Do Not Lift Cart with Power Source, Gas
Cylinder or any other equipment attached.
NOTE
Power Source MUST be mounted onto base
assembly before mounting wire feeder to
handle assembly.
!
WARNING
Do Not Exceed a maximum weight of 110 lb
(50 kg) on the top shelf of the base assembly.
Do Not Exceed a maximum weight of 88 lb
(40 kg) on the bottom shelf.
CAUTION
Do Not Exceed the Cart total load capacity of
298 lb (135 kg).
Manual 0-5221
Rev AA
Welding Equipment Basic Utility
Cart for Fabricator 181i / 211i / 252i
Part Number: W4014700
Assembly Instructions
© 2011 by Thermadyne Industries
General Information
The Thermal Arc Welding Equipment Basic Utility Cart
is specifically designed for the Fabricator 181i/211i/252i
to allow easy transport for the power source, gas cyl-
inder*, welding torch and various accessories. These
instructions will guide you through the proper assembly
procedure of the cart.
*Maximum Gas Cylinder 9" (230 mm) Diameter.
Recommended Tools
• Metric Hex Key Size 4 and 6
• Open End Wrench Metric 19mm-22mm or 8”
Adjustable Wrench
• Pliers
Thermadyne Holdings Corporation
Suite 300, 16052 Swingley Ridge Road
St. Louis, MO 63017, USA
Telephone: 1-800-426-1888 • Fax: 1-800-535-0557
Email: [email protected]
www.thermalarc.com