Unitec Portal Installation Manual - Manual (Page 34)

P O R T A L T I
Portal Installation Manual Rev C 30
3.9 Camera Connection
The (optional) surveillance camera is attached to the front door of the Portal. The
camera is intended for use with a DVR or similar monitoring device installed at the
site. The coaxial cable routed to the camera is used to connect it to the monitoring
device. The coax cable will need to be terminated with a BNC connector similar to
the one shown in Figure 26.
Figure 26. BNC Male Plug for Camera Connection
3.10 Gate Wiring
In multi-lane applications, a Unitec or 3 rd party gate controller is required. Refer to the
instructions provided with the gate controller for connecting wires between it and the
Portal. If needed, a gate can be used with a single Portal and no gate controller.
Refer to for instructions on connecting the Portal to the gate.
3.11 Connecting the Reach Free ID Option
Refer to the installation instructions supplied with this product option.
Document #: PTL1001