Waring FP40C - Manual (Page 10)

10
DISASSEMBLY of BATCH BOWL PARTS
(FP40 & FP40C)
ALWAYS UNPLUG THE CORD BEFORE DISASSEMBLING
• Turn the bowl cover clockwise until the safety interlock tab on the cover is disengaged from the magnetic
safety interlock switch in the tower, and the tabs are clear of the groove in the tower. The right bowl
handle will be at a position between 4 o’clock and 6 o’clock. In this position you can lift the cover off
the bowl.
• Remove the large food pusher from the feed tube. Remove the small pusher from the large pusher.
Disassembly when Removing the S-Blade
• Remove the work bowl from the unit by rotating clockwise (left) to disengage the tabs on the bottom
of the bowl platform from the work bowl. When the right bowl handle is on the right (about 4 o’clock)
you can gently lift the bowl straight up and out.
It is recommended that you remove the bowl from the motor base before you remove the S-Blade.
• To remove the blade, keep a slight downward pressure on the top of the center hub of the blade while
removing the bowl from the motor base. This will form a seal to prevent food particles from spilling
into the center tube of the bowl, and onto the motor base or the work surface. Then remove the S-Blade
from the bowl. Handle the S-Blade with caution; the blades are extremely sharp.
Disassembly when Removing an Accessory Disc
• Do not remove the work bowl until the accessory disc is removed.
• Rotate the chute and cover clockwise until the safety interlock switch is no longer engaged, and the cover
can be removed. Remove the cover.
• To remove an accessory disc, insert your thumb and forefinger into the 2 finger holes in the surface of the
disc.
• When it is time to remove the accessory disc, rotate the disc counterclockwise as far as you can, and pick
the disc straight up. The rotation moves the locking pin out of the slot in the disc’s center hub.
Note: The FP40 and FP40C food processors have a locking mechanism that will secure the discs in place
while the machine is running. Two locking pins on the shaft mesh with slots in the hub of the accessory disc
and hold it securely in place. Rotating the disc counterclockwise releases the locking pins from the slot.
Remove the work bowl from the unit by rotating clockwise (left) to disengage the tabs on the bottom of the
bowl platform from the work bowl. When the right bowl handle is on the right (about 4 o’clock), you can
gently lift the bowl straight up and out.