ClearOne Interact Manual - Manual (Page 40)

Chapter 2: Getting Started 35
MIC AND MIC EX SETTINGS - INTERACT AT ONLY
Level
The Level tab lets a user adjust level settings for each of the INTERACT MIC’s three microphones
independently.
• Fine Gain: Use the slider to adjust Fine Gain for each Mic Input independently
• Level Meter: Displays current levels for each Mic Input
• ALC: Click the ALC button to activate Auto Level Control for each Mic Input independently
• Mute: Click the Mute button to mute each input independently
• P Pwr (MIC EX only): Click the P Pwr button to enable Phantom Power for the Mic channel.
Processing
The processing tab adds processing and filters to each microphone based on user preference.
• AEC: Click the AEC button to activate Acoustic Echo Cancellation
• NLP: Default is Soft. Click a radio button to set the Non-Linear Processing level or deactivate the feature.
• NC: Click the NC button to activate/deactivate Noise Cancellation. Use the slider to adjust the amount of
noise cancellation used for that microphone.
• Speech Lift: Click the Speech Lift button to route the microphone’s audio to the Loudspeaker output.
Use the Speech Level Slider to set the desired level (the default is -6 dB).
• Filter: Click to apply filtering to each independent Mic Input.
• Start by clicking Add Filter
° Adjust the filter placement by moving the point along the grid (Hz, dB/deg).
` Alternatively, click Table View to apply a list view.
° To adjust the active filter, click the fields along the top row.
` Active Filter: Selects the filter to adjust
` Type: Sets the type of filter applied
` Frequency: Adjusts the frequency of the filter
` Gain: Increases or decreases gain applied to the filter
` Q: Increases or decreases the Q applied to the filter
` Bandwidth: Adjusts the filter’s bandwidth
` Bypass: Bypasses the filter completely
° To add phasing to a filter, click Phase
° Click Bypass All to override all filter settings
° Click Remove Filter to delete the selected filter
° Click Close to apply settings and close the window
° To remove an existing filter, open the Processing tab, click Remove Filter and Close.