ClearOne Interact Manual - Manual (Page 42)

Chapter 2: Getting Started 37
PLAYBACK INPUT SETTINGS - INTERACT AT
The Playback Input Settings window is used to customize and configure the audio from the playback device
that is connected to the Playback jack on the INTERACT mixer. Playback devices include VCRs, DVD players
and sound cards.
» NOTE: Some of the most common Playback devices have been pre-configured for optimal
performance with the INTERACT system. These devices are listed in the Device Toolbox.
Adding a Device Label
• You can add the Manufacturer and Model of your connected Playback device using a serial command.
• You can also add your Playback device to the Device Toolbox using the Device Toolbox Editor, which
allows you to specify the Manufacturer and Model.
Equalization
u
se
e
qualizers
• Equalization in INTERACT Software is very similar to bass and treble adjustments on a stereo.
Increasing or decreasing the different frequencies allows you to customize loudspeaker audio and
provide the optimal listening experience for your users. Using this feature is optional.
Stereo Mix
e
nable
s
Tereo
M
ix
• Select Stereo Mix if your external device uses Stereo Inputs/Outputs. The INTERACT provides
mono-only audio from stereo devices. By selecting Stereo Mix you ensure the proper level adjustments
are made to your audio.
Meters and Volume
a
djusT
v
oluMe
• Get an Audio Signal from the line Input Device.
• Adjust the Volume using the Volume Slider.
l
earn abouT
u
sing
M
eTers
• The meters are peak meters measuring the audio level. The nominal level is -10 dBu. The meter bars
move from green to yellow to red as the volume increases. The red bars indicate that the audio is too
loud and is being clipped or cut off.