ClearOne Interact Manual - Manual (Page 57)

52 Technical Support: 800-283-5936
PRESETS - INTERACT Pro
Presets for an entire device configuration can be saved for the INTERACT Pro (maximum of 4). Presets
save the configuration currently running on the INTERACT Pro. When the Preset is run it re-configures every
setting on the unit.
Settings not saved to a Preset include: Network, RS-232, Phonebook, Regional, ON/OFF Hook State of
Telco, Telco Configuration Properties and Meter Activation.
Saving a Preset
1. Make all changes to your configuration you want included in the Preset.
2. In the Flow Control, click Presets
3. Enter a Name into one of the available slots
4. Click Save to store the current configuration
5. Click Yes to confirm saving or No to cancel
6. Click Close to exit the Preset window
Running a Preset
1. In the Flow Control, click Presets
2. Click the Run button which corresponds to the preset you wish to load
3. Click Close to exit the Preset window
DIALER - INTERACT Pro
In addition to the INTERACT Controller, you can manage calls through the Dialer in INTERACT Software. You
can dial a number, redial the last dialed call, and disconnect calls. You can also use hook flash function,
mute the microphones, adjust call volume and change between Telco and PC modes.
Making and Receiving Calls
o
pen The
d
ialer
» NOTE: A connection must be present for the dialer to work on the AT. A connection is not
necessary for the INTERACT Pro.
• Click the Dialer icon on the flow window.
M
ake a
C
all
1. While connected to an active phone line, click the ON/OFF key. You will hear a dial tone.
2. Dial the number as you would on a standard phone. The number appears on the LCD screen as it dials.
» NOTE: You can also pre-dial the number and then press the ON/OFF key to connect the call.
Press and hold the pound key (#) to enter a pause in the dialing string.