ClearOne Interact Manual - Manual (Page 49)

44 Technical Support: 800-283-5936
INTERACT Pro - Audio Conferencing Setup
1. If needed, connect the INTERACT Pro 8i to the mixer with the included CAT5 cable.
2. Connect the microphones as needed.
3. Connect the amplifier to the mixer. The unit is by default set to Output 8 for Echo Cancellation but is
configurable based on needs.
4. Using the RJ-11 cable, connect an analog telephone jack to the Line jack on the mixer.
5. Using an RJ-11 cable (not supplied), connect an analog telephone set to the Set jack on the mixer
(optional).
6. Using the CAT5 cable, connect the mixer to the network. (Network settings can be changed within the
INTERACT software.)
7. Connect the power supply to the INTERACT Pro.
8. If using the wired controller, connect the controller to the mixer’s RS-232 serial port using the supplied
RJ-11 to DB-9 adapter. If using the RF controller, attach the external antenna and turn it until it is upright.
9. If using the RF controller, insert four AAA batteries into the battery compartment in the bottom of the
Dialer-W unit.
DEVICE TOOLBOX - INTERACT Pro
The audio settings for many common auxiliary audio devices such as video codecs, video playback devices,
amplifiers and sound cards, have been pre-configured for optimal performance with the INTERACT Pro
system. These devices are listed in the Device Toolbox section.
» NOTE: If your device is not listed, you can configure it manually or add it to the Device
Toolbox using the Device Toolbox Editor.
Adding a Device
a
dding
d
eviCes To The
d
eviCe
T
oolbox
1. Click the plus sign “+” to expand a category.
2. Right-click the category name and select Device Toolbox Editor.
3. Click the Add button.
4. From the Device Type dropdown, choose the category of device you’re adding. Enter a Manufacturer
name into the Manufacturer field and a Model name/number into the Model field.
5. If the device uses a Stereo connection, click the Stereo radio button. This setting enables input/output
assignment for the stereo channels.
6. EQ Sliders are available for the Low, Mid and High frequency ranges. Adjust the EQ sliders as needed
to set a desired sound quality level for each device.
7. Use the Output Gain Slider to adjust the default output level for your device.
8. Click Ok to save, Cancel to abandon the changes.
e
diTing
d
eviCes
1. Click the plus “+” sign to expand the category with the device you want to edit.
2. Right-click the specific device to edit, click Edit.
3. Follow steps 4-7 from
Adding Devices to the Device Toolbox to complete the edit process.
4. Click Ok to save, Cancel to abandon the changes.
d
eleTing
d
eviCes
1. From the Device Toolbox click the listed device you wish to delete.
2. Click the Delete button, when the Confirm dialog box appears, click Yes to complete the device
removal.