Electrical installation, Caution – Wheatheart Livestock Waterer User Manual

Page 13

Advertising
background image

W

HEATHEART

- L

IVESTOCK

W

ATERER

3. I

NSTALLATION

M

ODELS

: H50, H50L, EH50, EEFH50, SH50, ESH50, C50, EC50, C100, EC100, C200, EC200

IM11 R1

13

3.3. ELECTRICAL INSTALLATION

Note:

All electrical connections and wiring must be completed in accordance with the

current edition of the Canadian Electrical Code and/or the United States National

Electrical Code.

1. Run a watertight 3-wire conductor to the open knockout hole on the side of

the receptacle/switch box.

2. Use an approved strain relief connector to attach the conductor to the box.
3. Secure the ground wire to the ground lug located inside the box.
4. Connect the white supply wire to the white pigtail and the black supply wire to

the black pigtail using a properly-sized twist connector.

5. Replace switch faceplate on box and turn on power at source.

Figure 3.3 Electrical Installation

CAUTION

All electrical work must be done by a qualified
electrician in accordance with all applicable
codes, standards, and the instructions
contained within this manual.
Be sure to ground waterer at junction box
terminal.

Advertising