Wheatheart Livestock Waterer - Manual (Page 9)

W HEATHEART - L IVESTOCK W ATERER 2. S AFETY F IRST
M ODELS : H50, H50L, EH50, EEFH50, SH50, ESH50, C50, EC50, C100, EC100, C200, EC200
IM11 R1 9
• Follow good shop practices:
• keep service area clean and dry
• be sure electrical outlets and tools are properly
grounded
• use adequate light for the job at hand
• Think SAFETY! Work SAFELY!
2.2. INSTALLATION SAFETY
• Check all equipment for damage immediately upon arrival. Do not attempt to
install a damaged item.
• Have 2 people handle the heavy, bulky components.
2.3. OPERATIONAL & MAINTENANCE SAFETY
• Ensure that electrical cords are in good condition; replace if necessary.
• Ensure the fan inlet is not plugged with any foreign material.
• Keep inlet screen in place at all times.
• Before resuming work, install and secure all guards. Keep guards in good
working order.
• Ensure parts are in good condition and installed properly.
2.4. SAFETY DECALS
• Keep safety decals clean and legible at all times.
• Replace safety decals that are missing or have become illegible. See decal
location figures that follow.
• Replaced parts must display the same decal(s) as the original part.
• Safety decals are available from your distributor, dealer, or factory.
2.4.1. D
ECAL
I
NSTALLATION
1. Decal area must be clean and dry, with a temperature above 50°F (10°C).
2. Decide on the exact position before you remove the backing paper.
3. Align
the decal over the specified area and carefully press the small portion
with the exposed sticky backing in place.
4. Slowly peel back the remaining paper and carefully smooth the remaining
portion of the decal in place.
5. Small air pockets can be pierced with a pin and smoothed out using the sign
backing paper.