Great Plains NTA2007HD Operator Manual - Manual (Page 110)

106 Great Plains Manufacturing, Inc. Contents Index NTA607/2007HD
166-283M Contents Index 04/04/2011
Hopper Strap Maintenance
Refer to Figure 91
A new drill requires frequent attention to the hopper
straps, as the hoppers seat, and periodic attention there-
after, due to continued hopper seating and strap stretch-
ing.
Check tension before and after filling a hopper, and at
the end of each day. Seasonally inspect the straps for
wear and damage. Replace any that are frayed or torn.
Tighten nuts on tensioning bolts until straps cannot
slide side to side on hopper face , then tighten nuts two
additional turns.
Null4:
Chain Maintenance
Initially check the drive chains after the first 10 hours of
drill use. The slack of new chains tends to increase dur-
ing the first few hours of operation due to seating. There-
after, check the chains every 100 hours.
Lubricate chains any time there is a chance of moisture,
and when being stored at the end of the planting season.
Chain Slack
Refer to Figure 92, which, for clarity, greatly exaggerates
slack, and omits the idlers.
1.
Measure the span for allowable slack:
Locate the longest span of each chain (usually the
span which does not run through the idlers).
2. Determine the ideal slack:
Long chains (over 91cm/36in): 2.1cm/m (
1 ⁄
4
in per ft)
Vertical short chains: 2.1cm/m (
1 ⁄
4
in per foot)
Horizontal short chains: 4.2cm/m (
1 ⁄
2
in per foot).
3. Measure the current slack :
Acting at a right angle to the chain span at the center
of the span, deflect the chain in both directions. The
slack is the distance of the movement.
4. Adjust the idlers for ideal slack.
Whenever mounting a chain, make sure the clip at the
removable link is oriented to minimize snags.
Refer to Figure 93 (arrow shows chain direction)
Install clip with open end facing away from direction of
chain travel (shown by gray or striped arrows in chain
routing diagrams).
Null4:
Figure 91
Hopper Strap Tensioning
31412
1
1
2
2
1
2
Null4:
Maintenance
.eps
50%
Figure 92
Measuring Chain Slack
27264
2
1
1
Null4:
.eps
60%
Figure 93
Chain Clip Orientation
26482
2