Great Plains ADC1150 Predelivery Manual - Manual (Page 6)

3
Section 1 Assembly
4/7/04 ADC1150 Air Drill Cart 167-101Q
Great Plains Mfg., Inc.
Install Walkboard and Upper Ladder
Refer to Figure 1-2.
1. Unstrap the upper ladder (1) from the handrails (2).
2. Loosen the retaining clips (3) holding the walkboard to
the handrail. Slide the walkboard out until the edge of
the walkboard is 9 1/2 inches from the cart bin.
3. Remove bolts holding upper ladder to the walkboard
(4). Flip the ladder over to the upright position. Re-
place and tighten bolts.
4. Bolt the ladder to the handrails using 5/16-by-1 1/4-
inch bolts and flat washers (5) and flat washers, lock
washers and nuts (6).
5. Retighten retaining clips on walkboard.
16973
Figure 1-2
Upper Ladder and Walkboard
Install Lower Ladder
Refer to Figure 1-3.
1. Unscrew the two black knobs (1) from the lower-lad-
der bracket (2) on the left side of the cart.
2. Hang the lower ladder (3) over the bracket.
3. Align holes in ladder and bracket. Screw the black
knobs into place.
16435
Figure 1-3
Lower Ladder Installation
Assemble Auger
Three support arms connect the optional auger to the left
side of the cart. The center swing arm is in two pieces that
you assemble. The front and rear arms are bolted to the
cart.
Refer to Figure 1-4.
1. Connect the inner section of the swing arm (1) to the
outer section (2).
a. Check that the upper and lower joint bushings (3)
are in place.
b. Install the spacer (4) between the joint bushings.
c. Slide the outer arm into the inner-arm joint until
bolt holes are aligned.
d. Install the 3/4-by-6-inch bolt (5), lock washer (6)
and nut (7). Tighten so the spacer is held firmly.
!
DANGER!
Electrocution hazard–keep clear of overhead power lines when
positioning auger.
!
WARNING!
Auger weighs about 300 pounds and may cause injury if it falls.
Secure an adequate lifting device on auger while installing.
2. Install auger.
a. Put two washers (8) on top of swing-arm bushing.
b. Lower the auger swivel (9) into the bushing.
c. Place a washer (10) on the bottom of the installed
swivel. Secure with the 3/8-by-2-inch roll pin (11).
16157
Figure 1-4
Swing Arm and Auger