Great Plains ADC1150 Predelivery Manual - Manual (Page 8)

5
Section 1 Assembly
4/7/04 ADC1150 Air Drill Cart 167-101Q
Great Plains Mfg., Inc.
Route Auger Hoses
!
WARNING!
Escaping fluid under pressure can penetrate the skin causing
serious injury. Check all hydraulic lines and fittings before ap-
plying pressure.Use paper or cardboard, NOT BODY PARTS, to
check for suspected leaks. Wear protective gloves and safety
glasses or goggles when working with hydraulic systems. If an
accident occurs, see a doctor immediately. Any fluid injected
into the skin must be surgically removed within a few hours or
gangrene will result.
Refer to Figure 1-7.
Two hydraulic hoses connect the valve on the auger body
(1) to the diverter on the cart tongue (2). After installing the
auger, secure the hoses to the auger swing arm to prevent
hose damage.
1. Loosen but do not remove the bolts holding the hose
clips on the swing arm.
2. Route hoses over swing arm as shown in Figure 1-7.
Use the hose clips to secure hoses. Allow enough
hose slack between clips for auger arm to fold and un-
fold. Figure 1-7 has approximate lengths.
3. Swing the auger as if loading and unloading the cart.
(Refer the Filling the Cart and Unloading the Cart,
“Operating Instructions” in the operator’s manual.)
Check that hoses do not bind. Increase hose slack be-
tween clips if necessary.
4. When satisfied with hose slack, snug clips over hoses.
Do not overtighten clips.
Figure 1-7
16208
Hydraulic Hose Routings