Setup seed monitor for air drill, Row setup data, Row spacing and swath – Great Plains ADC2350BE Operator Manual User Manual

Page 33: Cta4000 air drill implement, Cta4000hd air drill implement

Advertising

Great Plains Manufacturing, Inc.

Table of Contents

Index

Preparation and Setup

2012-08-01

Table of Contents

Index

167-085M

Setup Seed Monitor for Air Drill

With the monitor terminal installed (see page 18), the
cart hitched and the implement hitched, the monitor can
be set up with information that rarely changes (as well as
with defaults for planting-specific information to be
changed later).

If the monitor inputs are correctly entered, the monitor is
a handy tool to allow you to fine tune the variable rate
gearbox setting.

Row Setup Data

CTA4000 Air Drill Implement

CTA4000HD Air Drill Implement

See the DICKEY-john

Quick Start guide for

more detailed instructions. This Operator’s
manual section provides only cross-references
to information required

Note: Monitor setup menus are not enabled

until all monitor harness connections are
made

25421

Row Spacing and Swath
If “Auto Update Width” is set to “Disabled”, a
precise (swath averaged) row spacing is not
needed.

Model

CTA4000-8006

CTA4000-6575

CTA4000-5010

Row Count

Nominal Row Spacing

6 inches (15.2 cm)

7.5 inches (18.9 cm)

10 inches (24.8 cm)

Swath Averaged Row Spacing

6.08 inches (15.45 cm)

7.49 inches (19.0 cm)

9.75 inches (24.77 cm)

Swath [Width]

486.5 inches (1235.7 cm)

487.1 inches (1237.2 cm)

487.5 inches (1238.6 cm)

Number of Towers

5 (16 ports per tower)

5 (13 ports per tower)

5 (10 ports per tower)