Great Plains ADC2350BE Operator Manual - Manual (Page 51)

Great Plains Manufacturing, Inc. Table of Contents Index Operating Instructions 47
2012-08-01 Table of Contents Index 167-085M
16. Start the auger by turning the auger direction valve
off center to the left or right. Visually check auger for
correct rotation direction. Reverse handle if needed.
See “Auger Hydraulic Controls” on page 39.
17. Slowly turn on material flow and fill hopper.
Note: Hopper fill level indications are molded into the side
of the hopper.
18. When hopper is full, turn off the auger by moving the
auger direction control to the center position.
19. Briefly run auger in reverse to return any residual
material to the inlet hopper for recovery or disposal.
20. Return auger to storage position. See “Storing
Auger” on page 40.
21. Turn off the tractor hydraulics.
Do not turn the auger hydraulic diverter handle until the
hydraulics have been shut off. If the diverter is moved with
hydraulics on, other equipment may suddenly begin moving.
22. When circuit is off, set diverter to up (pass-through to
markers or fan). See “Auger Hydraulic Controls”
on page 39
23. Remove any foreign matter from the strainer basket.
24. Wipe any grain or foreign matter from lid-seal area
on top of cart bin. Close lids and latch securely.
Unloading the Cart
The cart auger can be swung under the cart to unload
material in hoppers. The material must be in a
free-flowing state. If the material will not flow out the
clean-out door, see “Problem Clean-Outs” on page 77.
For normal unloading:
1. Securely hitch cart or drill+cart to a tractor with
adequate weight and power. Park cart on solid, level
ground. See Tractor Requirements, “Minimum
Towing Vehicle” on page 41.
2. Shut off all hydraulic power to the cart.
12713
12713