Great Plains YP1625 Operator Manual - Manual (Page 134)

401-226M-A 03/12/2012
130 YP1225 and YP1625 Great Plains Manufacturing, Inc.
Appendix R - Row Pro
Preparation and Setup
Row-Pro™ Setup (Option)
The factory default setting for down-force is likely to differ
from that required by your next field conditions.
Before modifying the monitor setting for down-force,
determine what actual down force is ideal for the initial
use of the planter. One method of determining an initial
setting involves operating in the field (without seeding).
1. Set planting depth at T-handles (page 54).
2. Review unit-mount coulter depth relative to opener
disc. Adjust as needed (page 59).
3. Set down-force cams to notch 3 (page 54).
4. Operate
n
in the field for a short distance.
5. Evaluate the furrow (page 55).
6. Adjust the cams until depth and closure are ideal. If
the ideal setting seems to be in between two notch
values, use the higher setting. Rows in tracks may be
higher still.
7. Engage the Row-Pro™ system. Start with a force
setting lower than the chart value for the cam notch
(see table on page 54).
8. Operate in the field. Evaluate furrow and closing.
Adjust Row-Pro™ force setting for optimal results.
9. When verifying the final setting, and when planting,
watch for Unable to Control alarms, which may indi-
cate that the cams are a notch or more too high or
too low.
n. Optionally operate the Row-Pro™ system in Diagnostic mode, and note the forces reported.
Null4:
31549