Great Plains 4000TM Assembly Manual - Manual (Page 40)

36 3500-4000TM Great Plains Manufacturing, Inc.
586-537Q-ENG 12/03/2013
Front Light Assembly
Refer to Figure 26
110.Fasten LH and RH light brackets to center
brace bar with 1/2 x 3 1/32 x 6 u-bolts , 1/2 lock
washers and 1/2 huts.
111.Route light harness lead w/valve from front of
hitch (tractor plug to front), along same route as
hydraulic hose (fasten in same clamps and hose
wraps as hoses) to center brace bar. Plug one end of
enhance light harness
to small end of light har-
ness lead w/valve . Plug bigger end of light har-
ness dual amber into other end of enhance light
module . Route shorter leads over towards
(marked left and right) the front light mounting brack-
ets as shown. Route long lead
along hoses on
center frame tube to rear of machine. This lead will
be hooked up as shown in, See “Rear Lights &
SMV” on page 37.
112.Mount amber lamp lights to top of light brackets
and , with 1/4 x 1 Gr. 5 hex bolts and 1/4 lock
nuts. Plug lead of amber lamp lights into leads of
light harness dual amber .
113.Tighten all bolts with lock nuts snug, but do not
torque. The rest of the bolts may be tightened to
specs, See “Torque Values Chart” on page 46. Be
sure and get all wiring harnesses fastened up
securely with hose wraps or clamps (if routed close
to hydraulic hoses) or use cable ties
.
1 2
3
4
5
4
6
5
6
7 1
2 8
7
6
9
6
3
4
4
U
D
F
B
L
R
1
3
8
7
6
9
9
5
6 6
8
7
Figure 26
Front Lights 43260
2