Great Plains ADC2350B Assembly Instructions - Manual (Page 3)

Great Plains Mfg., Inc.
Installation Instructions 3
03/05/2009 166-255M
Pre-Assemble Components
Assemble New Auger Carrier Latches
Refer to Figure 3
5.
Select two (2) each new:
166-188H AUGER TRANS LATCH PULL BEHIND
816-570C 8 INCH AUGER CLAMP PAD
(this is the shorter of the two sizes of EPDM pads)
and eight (8) sets new:
802-888C ELEVATOR BOLT 1/4-20X3/4 PLT:
804-006C WASHER LOCK SPRING 1/4 PLT
803-006C NUT HEX 1/4-20 PLT
6. The clamp pad may have two, four or no holes,
and may or may not have adhesive on one side,
protected by release paper. If four holes are not
present, it is necessary to assembly-drill them.
Position the pad so that it is centered in the latch
weldment
. Mark holes for fractional size
9 ⁄
32
in
(letter size K, 7.2mm). Remove pad and punch or
drill holes.
7. Remove any release paper. Position a clamp
pad
, adhesive side to inside of latch face. Insert
the elevator bolts through the inside of the pad
and secure with lock washers and nuts
8. Select the latch side of two (2) each new:
800-285C AUGER LATCH CLAMP
and eight (8) sets new:
802-007C HHCS 5/16-18X3/4 GR5
804-009C WASHER LOCK SPRING 5/16 PLT
803-008C NUT HEX 5/16-18 PLT
Mount the latch clamps at the top of the latch
weldments , inside the double break, using the
bolts , lock washers and nuts
Assemble New Auger Carrier Rests
Refer to Figure 4
9.
Select two new:
166-187H AUGER CARRIER PULL BEHIND
and one each new:
802-114C HHCS 3/8-16X2 1/2 GR5
803-014C NUT HEX 3/8-16 PLT
804-013C WASHER LOCK SPRING 3/8 PLT.
10. Loosely thread the nut fully onto the bolt , add
lock washer , and loosely thread fully into coupler
nut at the bottom of the carrier weldment .
This carrier is designated the rear carrier, and is the
only one with a stop bolt in the coupler nut
.
Figure 3
Auger Latch
29373
13
39
22
29
32
32
26
26
25
25
17
18
33
27
13
39
25
32
26
39
13
39
25
32 26
Figure 4
(Rear) Auger Carrier
29373
12
34
28
21
1
26
32
25
38
32
26
25
17
18
33
27
17
13
18 33 27
12
21
28
34
28 21
34
1 12
1