Great Plains PT1230 Predelivery Manual - Manual (Page 5)

2
Section 1 Assembly
PT1230 Folding Pull-Type Planter 401-072M 10/14/08
Great Plains Mfg., Inc.
Section 1
Assembly
The following headings are step-by-step instructions for
assembling the planter. Begin with Tools Required and
Pre-Assembly Checklist to make sure you have all neces-
sary parts and equipment. Then proceed with Planter As-
sembly. Follow each step to make the job as quick and
safe as possible and produce a properly working machine.
The planter is shipped via flat bed truck. It is the dealer’s
responsibility to unload the new machine. Unload all
equipment before beginning assembly. Do not attempt any
assembly work while the planter is on the truck.
Tools Required
•
Forklift with 3,000 pound capacity
•
Lifting chains
•
General hand tools
Pre-Assembly Checklist
1. Read and understand “Important Safety Informa-
tion” on page 0 before assembling.
2. Have at least two people on hand while assembling.
3. Make sure the assembly area is level and free of ob-
structions (preferably an open concrete area).
4. Have all major components.
5. Have all fasteners and pins shipped with the planter
IMPORTANT: If a pre-assembled part or fastener is
temporarily removed, remember where it goes. Keep
the parts separated.
.
6. Have a copy of the parts manual on hand. If unsure of
proper placement or use of any part or fastener, refer
to the parts manual.
7. Check that all working parts are moving freely, bolts
are tight, and cotter pins are spread.
8. Check for proper tension and alignment on all drive
chains.
9. Check that all safety labels and reflectors are correctly
located and legible. Replace if improperly located or
damaged. Refer to Safety Labels, “Important Safety
Information” in the operator’s manual.
10. Inflate tires to recommended pressure as listed on the
Tire Inflation Chart on the “Appendix” on page 11.
Tighten wheel bolts as specified on Torque Values
Chart on the “Appendix” on page 11.
Planter Assembly
!
WARNING!
The fertilizer-tank weldment weighs more than 300 pounds and
could cause serious injury if it falls. Make sure the weldment is
securely attached to an adequate lifting device. Keep people
away while the weldment is being lifted. Do not place any body
parts under the weldment at any time.
1. If the planter has liquid fertilizer, remove fertilizer-tank
weldment from the planter frame. Secure adequate
lifting device to the weldment. Unstrap the weldment
from the planter frame. Loosen and remove the bolts
that hold the weldment on the planter. Save bolts,
washers and nuts. Lift the weldment off the planter
frame and lower weldment to the ground.
2. Refer to Figure 1-1. Attach tongue assembly (1) to
frame assembly (2) by installing nut straps (3) with 1-
by-2 1/2-inch hex bolts (4) and USS flat washers (5).
Install front bolts first. Torque bolts as listed on Torque
Values Chart, “Appendix,” page 11.
15898
Figure 1-1
Tongue and Frame Assembly