Install sensor mount, Install sensor, Cut cover clearance holes – Great Plains PD8070 User Manual
Page 4
Advertising
Great Plains Mfg., Inc.
4
Update Kit
402-231M
02/02/2007
Install Sensor Mount
15. Select one new:
HALL EFFECT SENSOR MNT- PRE 07
and two each new:
802-005C HHCS 1/4-20X1 GR5
803-006C NUT HEX 1/4-20 PLT
804-006C WASHER LOCK SPRING 1/4 PLT
16. Install the mount outside the shield
Install Sensor
17. Select one new:
18. Remove one plastic nut
from the sensor, and
install it on the sensor mount. Temporarily adjust
the exposed length of sensor so that the end of the
sensor is just inside the shield
Cut Cover Clearance Holes
19. Position the cover
against the shield
and
mark areas where the lip of the cover must be cut
away.
20. Test fit the cover
and file any sharp edges.
Figure 8
Install Mount
26005
Figure 9
Install Sensor
26006
1
1
Figure 10
Mark for Clearance
26000
Advertising