Install pickup wheel and sprocket, Adjust sensor position – Great Plains PD8070 User Manual
Page 5
Advertising
Great Plains Mfg., Inc.
Installation Instructions
5
02/02/2007
402-231M
Install Pickup Wheel and Sprocket
21. Select again the one new:
and each of the existing:
PIN COTTER 1/4 X 2 PLT
SPKT 40C15 X 7/8 HEX BORE
WASHER FLAT SAE 1
22. On the shaft, install the disc
, washer
sprocket
and cotter pin
Adjust Sensor Position
23. Turn the upper plastic nut of the sensor to adjust
sensor gap
. Set gap 6mm to 7mm between bot-
tom end of sensor
.
24. Rotate the disc
to verify clearance.
Tighten the upper nut.
25. Re-mount the chain (on the sprocket
, NOT on
the sensor disc
. Tighten the idlers
.
26. Re-mount the cover
and secure it with knob
.
Figure 11
Final Wheel Install
26007
Figure 12
Adjust Sensor Position
26008
26013
1
6-7mm
Figure 13
Re-Mount Chain
26009
1
Advertising