Great Plains DVN8324 Predelivery Manual - Manual (Page 13)

Great Plains Manufacturing, Inc. Assembly 9
11/25/2013 550-466Q
Install Magnum Shanks
Refer to Figure 7
32. The shank mounts will be shipped in correct location
from factory. If something got moved during shipping,
go to the layout section of “Operator’s Manual” for
proper placement.
33. The 1/2 x 1 1/2 bolt will need loosened clear up but
do not take clear out. The 3/4 hex jam nut should
be shipped a little loose so the shank cradle can be
pivoted to install the 5/8 x 2 bolt
.
34. Locate shank assemblies from misc. box and remove
the 5/8 x 2 bolt from shank assembly .
35. Slide shank assembly through shank cradle in
shank mount and align holes as shown below.
36. Re-attach 5/8 x 2 bolt , secure with 5/8 lock nut.
37. Bolt may be tightened to specs, See “Torque Val-
ues Chart” on page 13.
Note: Re-tighten 1/2 x 1 1/2 bolt until threads bottom
out. Be sure and tighten 3/4 hex jam nut until
thread bottom out to ensure that hole doesn’t wear
excessively.
38. Repeat same procedure for rest of shanks.
Attach Disc or Coulter Gangs
Refer to Figure 8
39. The gang hanger assemblies
will be shipped
mounted to machine in proper location.
40. The L bundle number will written on a blade of each
disc or coulter gang assembly . See layout section
of “Operator’s Manual” for proper placement.
41. Remove the 1 x 5 1/2 pin and the 3/4 x 2 1/2 pin
from gang hanger assemblies as shown.
42. Move disc or coulter blade assembly into positions
with a fork truck or overhead hoist and align holes.
Re-install the 1 x 5 1/2 pin
, secure with the 3/8 x 2
1/4 bolt and lock nut. Re-install the 3/4 x 2 1/2 pin
to spring assemblies , secure with 3/4 flat
washer and cotter pin.
43. All bolts may be tightened to specs, See “Torque Val-
ues Chart” on page 13. Bend over cotter pins.
44. Repeat same procedure for rest of gangs.
Figure 7
Magnum Shank
41634
3
2
4
U
D
F
B
L
R
1
1
1
5
2
2 3
3
4
2
2
1
5
Figure 8
Disc or Coulter Gangs
41635
6
5
4
2
1
3
2
1
3 6
2
1
3
4
6 5