Great Plains 2SBM30 Operator Manual - Manual (Page 16)

2SBD30 30-Foot, Folding, Soybean Machine 173-086M 5/3/05 14 Great Plains Mfg., Inc.
Section 3 Hydraulics
2. When folding the machine, the machine transport
stabilizer frames should line up with the nests on the
front of the main frame, Figure 3-6.
If they scrape the wing on the tongue, the boxes can
be raised or lowered by adjusting the wing adjust-
ment clevis, Figure 3-7.
10673
Transport Stabilizer Frame
Figure 3-6
Pull Bar Adjustment
With the machine completely unfolded, the drill boxes
should be in line with each other, and parallel to the
back of the main frame.
Should your drill boxes require alignment, simply dis-
connect the screw clevis end of the pull bar and screw it
in or out to move the box forward or backwards. Once
the boxes are aligned, be sure the pull bars are pinned
to the tongue slide and that the tongue slide is pinned for
field position.
Transporting
Before transporting the machine, you should al-
ways check the following items:
1. To prevent possible damage in case of hydraulic fail-
ure during transport, Always insert safety lock pins
when transporting, Figure 3-3.
2. Check to be sure the pull bar transport lock pin is in
position to insure boxes will not open during trans-
port, Figure 3-2.
3. Check to see if you have the required air pressure in
your tires using the "Section 2 Tire Inflation Chart"
on page 7.
4. When in transport, use accessory lights and devices
for adequate warning to other operators of other ve-
hicles, and use safety hitch chain. Comply with all
10674
Wing Adjustment Clevis
Figure 3-7