Great Plains Min-Till Ladder Kit Assembly Instructions - Manual (Page 3)

Great Plains Manufacturing, Inc. Install Ladder Mounts 3
09/10/2007 195-066M
Refer to Figure 3 or Figure 4
Top mount weldments are provided in left-side (
) and
right-side ( ) versions and are not interchangeable. All
other parts may be used on either end. Start with the left
wing:
10. Select one:
195-063H LADDER MOUNT TOP WELDMENT LH ,
and four:
802-030C RHSNB 7/16-14X1 3/4 GR5.
11. Position the top mount over the four walkboard
holes appropriate for the drill’s configuration (see
page 2).
12. Insert the four bolts to loosely hold the top mount
in place on the walkboard .
13. Select one:
195-340D LADDER MOUNT BOTTOM PLATE
and four sets of:
804-014C WASHER LOCK 7/16 PLT
803-015C NUT HEX 7/16-14 PLT
14. Position the bottom plate under the walkboard
and inside the top mount . Loosely hold it in place
with the washers and nuts .
15. Select two sets of:
802-017C HHCS 3/8-16X1 GR5
804-013C WASHER LOCK SPRING 3/8 PLT
803-068C NUT HEX FLANGE 3/8-16 PLT
16. Insert the bolts through the side holes in both the
top mount and bottom plate , and secure with
lock washers and flange nuts .
17. Tighten the four 7 ⁄
16
in nuts on bolts , securing
the top mount to the bottom plate .
Refer to Figure 7 on page 6
18. Selecting one:
195-064H LADDER MOUNT TOP WELDMENT RH
in place of mount , repeat step 10 through step 17
for right wing section.
Figure 3
Small Seeds Mount Location
27055
13
17
16
4
22
20
15
23
19
13
14
13
17
13
4
17
4
15
23
19
15 4
13
23 19
Figure 4
Location, No Small Seeds
27036
13
17
16
22
20
15
23
19
4
16
22
20
16
13 15
22 20
19 17
13 15
14
13