Install reflectors and decals, Operations – Great Plains Min-Till Ladder Kit Assembly Instructions User Manual
Page 5
Great Plains Manufacturing, Inc.
Install Reflectors and Decals
5
09/10/2007
195-066M
Install Reflectors and Decals
The new ladder top mount may obscure existing decals
and reflectors on the walkboard. The ladder kit includes
replacements to apply as needed.
To install new reflectors and decals:
• Clean and dry the area where the reflector or decal
is to be placed.
• Peel backing from reflector or decal. Press firmly
on surface, being careful not to cause air bubbles
under reflector or decal.
Refer to Figure 6
Start on the left walkboard, outer end:
25. Select one:
838-265C DECAL REFLECTOR AMBER 1 1/2X9
Place the reflector decal on the outside of the ladder
mount
, between the ladder side plates
won’t be damaged by ladder operation)
26. Select one:
838-265C DECAL REFLECTOR AMBER 1 1/2X9
Place the reflector decal on the rear and corner of the
ladder mount
. This decal is slightly longer than
that side of the mount. Wrap the excess around the
corner.
27. Select one:
Place the 838-102C Danger decal
forward of and
near the top of the ladder, where it is visible to climb-
ers.
28. Repeat step 25 through step 27 for right wing walk-
board ladder.
Operations
Swing ladders up and onto walkboards during:
• folding and unfolding,
• transport,
• field operations,
• unattended parking, and;
• storage.
Figure 6
Replacement Decals
27016
12