Great Plains 2510HDF Operator Manual - Manual (Page 31)

Great Plains Manufacturing, Inc. Table of Contents Index Operating Instructions 27
2013-11-11 Table of Contents Index 288-340M
Parking
For information on long-term storage, refer to “Storage”,
next topic.
1. Empty seed box before unhitching drill to prevent drill
from falling backward.
Note: For parking with drill attached to an accessory
hitch, refer to your hitch operator’s manual.
2. Unload seed box:
Place tarp under drill or a bucket under each seed
meter.
Use a large bucket to empty box as much as
possible. Make sure sliding seed tubes are in the
open position. Open main seed box meter clean outs
to empty seed out of sliding seed tube and meter.
Thoroughly clean seed and seed-treatment residue
from boxes and seed meters.
3. Park drill on a level, solid surface.
4. If drill is equipped with parking stands, install them.
5. Lower three-point hitch until drill is on the ground.
6. Disconnect electrical harnesses.
7. Set circuits to float and disconnect any hydraulic
connections to the drill.
8. Extend or retract the top link of the tractor until top
three-point pin is free. Remove pin.
9. Remove pins from lower links.
Storage
1. Store the drill where children do not play. If possible,
store the drill inside for longer life.
2. Perform the Parking checklist, above.
3. Plug or cap delivery tubes to prevent pest entry and
nesting.
4. Remove any dirt and debris that can hold moisture
and cause corrosion.
5. Lubricate and adjust all roller chains.
6. Lubricate areas noted at “Lubrication” starting on
page 56.
7. Inspect drill for worn or damaged parts. Make repairs
and service during the off season.
8. Use spray paint to cover scratches, chips and worn
areas on the drill to protect the metal.
9. Cover with a tarp if stored outside.