Great Plains 4000-3S Assembly Instructions - Manual (Page 2)

113-728M 2/28/2006
Great Plains Mfg., Inc.
Marker Option 2
Note: For drills with a fertilizer drive use the follow-
ing instructions for mounting the first marker sec-
tion to the right-hand side of the drill.
Refer to Figure 2
3. Remove the 1/2" U-bolt located on the front of
the fertilizer drive mounting plate. Keep the lock
washers and nuts for later use.
4. Mount first marker section (1) on drill frame tube
(2) as shown. Secure with four 5/8" x
6" x 7 3/4" U-bolts (3), 5/8" lock washers (4) and
5/8" nuts (5).
NOTE: Mount the marker as far out on the frame
as possible.
5. Insert the two 1/2" x 7 1/2" bolts (6) through the
holes in the fertilizer drive mounting plate
where the U-bolt was removed.
6. Install the clamp bar (7) as shown and secure in
place with 1/2" lock washers (8) and 1/2" nuts (9)
removed in step 3.
Figure 2
Right-hand First Marker Section with Fertilizer Drive
21785