Great Plains CDA600 Operator Manual - Manual (Page 41)

39 Centurion CDA600
270-600M-ENG
2013-06-14
4. Adjustment / Operation
4.7.2 Boutmarker Disc
Adjustment
The boutmarker disc angle can be changed
using the adjuster at the end of the
extension arm. By loosening bolts A and
B the disc can pivot to the desired angle
before retightening.
Mark visibility may be enhanced by inverting
the disc on the disc axle. Remove the outer
axle nuts. Invert the disc and re-secure with
nuts.
Check marker extension after adjusting.
These adjustments may cause minor or
major changes to marker extension, which
could result in incorrect gaps between
bouts, or overlaps.
A
B
Figure 16. Boutmarker disc angle adjustment