Strainer, Setting relief valve, Strainer setting relief valve – Great Plains NTA2007 Material Rate User Manual

Page 35

Advertising
background image

Great Plains Manufacturing, Inc.

Contents

Appendix

Liquid Fertilizer Rates

33

2012-01-03

Contents

Appendix

167-085B

Strainer

Refer to Figure 15
A Banjo brand strainer is supplied with the ground drive
fertilizer pump. It is plumbed before the Hypro pump. The
standard 80 mesh screen

should be suitable for most

applications. Other sizes are available from Banjo.

If changing screen sizes, keep in mind the following.

• A smaller mesh (100) will keep very small manifold

orifice plates from plugging so often. However, the
screen will have to be cleaned more often.

• A larger mesh (50) or (30) will pass more material but

should only be considered when using large manifold
orifice plates.

• A plugged or partially plugged screen will starve the

pump resulting in a reduced application rate.

• Mesh sizes: (Smallest) 100, 80, 50, 30 (Largest)

Setting Relief Valve

Refer to Figure 16
A relief valve

and pressure gauge

is mounted at

front centre of cart on models NTA607/2007/HD.

The relief valve protects the manifold, lines and fittings
from excessive pressure. Any product that passes the
relief valve will discharge from the dump line

in relative

safety.

To set the relief valve:

1.

Unlock plastic jam nut

from relief valve knob.

2.

Unscrew knob

clockwise (looking down) until it

loses contact with internal spring.

3.

Screw knob

counter clockwise two turns.

Start at this setting.

4.

Observe manifold gauge

and watch for relief valve

dump line

discharge while operating in the field.

5.

If valve is dumping product and gauge reads under
65 psi, stop tractor and turn knob

clockwise

1

4

turn. Continue operating at normal field speed.

Repeat this step as needed until no product is
discharged from relief valve dump line

.

6.

If the pressure gauge reads above 65 psi, change to
a larger orifice. Go to step 2 and repeat.

Agricultural Chemical Hazard:
Wear protective gloves when changing strainer screens.
Consult material manufacturer or supplier documents for
proper handling and steps to take if skin contact occurs.

Figure 15

Strainer

18418

1

1

2

3

4

Figure 16

Fertilizer Relief Valve

31017

2

3

4

5

6

5

6

6

3

4

6

4

Advertising