Great Plains 10 Gallon Stainless Tank Foam Marker Operator Manual - Manual (Page 13)

4/21/2003 500-033M-A
11 Preparation and Setup
hose with boom feeder hose through boom pivot ar-
eas to ensure adequate hose length. Attach vinyl
hose to boom feeder hose with tie straps provided,
being careful not to pinch the vinyl hose. Before you
cut the hose, make sure that there is enough length
on the hose so that the boom can be completely
raised an lowered without stretching the hose. Posi-
tion the hose through the T-clips (6) along the boom
wing. Pull up the tabs on the T-clips and position the
hose in the T-clips after the hose has been routed.
8. Route a section of hose from the "FOAM LEFT"
hose barb on the foam marker box to the hose barb
(9) that comes out the side of the foam generator
cylinder on the left boom wing. Route vinyl hose with
boom feeder hose through boom pivot areas to en-
sure adequate hose length. Attach vinyl hose to
boom feeder hose with tie straps provided, being
careful not to pinch the vinyl hose. As before, make
sure that there is enough length on the hose so that
the boom can be completely raised and lowered
without stretching the hose. Position the hose
through the other side of the T-clip (6) along the
boom wing.
9. Repeat steps 6, 7 and 8 for the right boom wing.
Refer to Figure 1, on page 10
10. Attach the foam marker extension cord (8) from the
foam marker box (4) to the foam marker plug on the
control box.
Note: If your sprayer does not have the manual con-
trol system with the Application Systems control box,
you will need to purchase the 502-031A foam marker
kit which includes a small switch box to control the
foam marker.
Single Axle Sprayer / Foam Marker
Assembly Instructions and Set-Up
Refer to Figure 3
1. Mount the foam tank base (2) on the walkboard with
the two 3/8" x 1" long bolts (1) and one 3/8" x 2" long
bolt with the flat washers (6) and flange nuts (7) re-
quired.
2. Mount the foam marker box (5) onto the expanded
metal with four 3/8" x 1" long bolts (1), flat washers
(6) and flange nuts (7).
3. Secure the foam tank (4) to the foam tank base (2)
with the hose clamp (3) provided.
4. Attach a section of the clear hose from the hose
barb on the foam marker box (5) labeled "AIR TANK
IN" to the hose barb on the foam tank (4) that has a
white coupling. In a similar manner, attach a section
of the clear hose from the hose barb on the foam
marker box (5) labeled "FOAM TANK OUT" to the
black coupler on the tank. Attach the hoses with the
hose clamps provided.
5. Follow the instructions step 5 through step 10 on
page 10 to attach the foam generator cylinders.
Figure 3
Single Axle Foam Marker Assembly Illustration
11996