Great Plains 3P600 Assembly Instructions - Manual (Page 7)

3/31/2004 151-071M
Great Plains Mfg., Inc.
7 Installation Instructions
Agitator Paddle Installation
See
Figure 9
Agitator Paddle Assembly
18739
paddle 1
paddle 2
paddle 3
paddle 4
paddle 5
paddle 6
Figure 9:
1. Place an agitator paddle (1) over the hex shaft
directly above a feeder cup. Position paddle
as shown (paddle 1).
2. Slip a 1/4 x 2 inch hex flange bolt (2) through
the paddle and secure with a hex flange lock
nut (3).
NOTE: Before tightening a paddle or group of
paddles, carefully rotate the drive system to make
sure paddles do not hit the tray dividers.
3. Place a paddle over the next feeder cup. Ro-
tate this paddle 1/6th of a turn and slide it onto
the next set of flats as shown (paddle 2).
4. Continue the installation above each feeder
cup, rotating the paddle 1/6th of a turn each
time as shown ( paddles 3 through 6).
5. Start over with paddle 1 and continue until
each feeder cup has a paddle. The fully as-
sembled shaft will have a spiral result.
6. After checking for interference, torque the
paddle bolts to 9 ft. lbs. (108 in lbs.)