Great Plains 3P-FF900 Predelivery Manual - Manual (Page 13)

Preparation and Setup 11
11/09/2006 500-643Q
!
WARNING
Be certain that tractor lift capacity is adequate and that
tractor is weighted to maintain steering control. Failure to
do so may cause loss of vehicle control. Refer to tractor
specifications for tractor lift capacity and “
Specifications
and Capacities ” on page 14, for required lift capacity.
Consult the tractor’s operator’s manual for tractor weight-
ing recommendations.
Refer to Figure 6
5. Determine the pin and spacer orientation needed
for the tractor, and securely fasten the hitch pins.
6. Mount the 3-Point Sprayer to a tractor with the cor-
rect pin mountings determined from instruction
Step 1. Make sure that the sprayer frame is level
so that after the boom is assembled, it won’t hit the
tractor cab when the boom is folded or raised.
IMPORTANT !
The category 4 narrow hitch (CAT IV-N) spacers are
not standard parts supplied with the 3-Point Sprayer.
Order 501-011S from a Great Plains dealer for the
CAT IV-N spacers.
Note: Be sure that the top 3-Point link is adjusted cor-
rectly so that the frame is level in operating posi-
tion but will not hit the cab in transport. The
tractor 3-Point arms should be adjusted to keep
the sprayer level from side to side with lift
arm rigid.
Figure 6
Pin & Spacer Configuration
12654