Finger meter inserts – Great Plains 2525P Material Rate User Manual
Page 45
Great Plains Mfg., Inc.
43
03/23/2010
118-231B
Finger Meter Inserts
Refer to Figure
The backing plate is equipped with an “A” insert
. In
tests, this insert provides the best performance in most
seed sizes. However, there are two alternative inserts
that can be used. Before changing to a different insert,
please consult with a Great Plains service representa-
tive for a recommendation.
The identification of the insert type is molded into the
back of the insert.
IMPORTANT !
Be cautious in using seed treatments, additives, and
other chemicals when possible. They can cause
meter performance problems and premature wear to
meter parts.
Avoid the use of graphite with untreated seeds. If
graphite must be used, use Precision™ planting
graphite or Great Plains graphite which is less abra-
sive. Seeds with Maxi, Captan, Cruiser, Poncho and
similar treatments can benefit from graphite. Use the
amount recommended on the graphite container,
usually 1 tsp/unit or 1 tsp/80,000#.
Always store meters in a dry, secure place, with
brush in between two meter fingers. Moisture, tem-
perature, nest-building insects and rodents can cre-
ate problems.
Always pay attention to your seed monitor and oper-
ating manual. Monitor the amount of seed you are
planting compared to your expectations. Always
investigate abnormalities!
Figure 4
Finger Meter Insert
22908
1