Great Plains HD Series Operator Manual - Manual (Page 6)

6
Refolding the Harrow to Transport Position
1. Do not move the machine until wings are fully folded to transport position. With engine
running at low RPM, slowly operate the hydraulic lever to raise the sections to vertical.
WARNING:
Do not walk or allow others to walk behind harrow when it is in the unfolded
vertical position. Hydraulic malfunctions or the hitch pin coming loose could allow the
harrow to tip over causing serious injury.
2. As the wings start to fold inward, make certain that the spring operated cable lift arms are
lifting the cables. If the cable arms are not lifting properly, they will be damaged by the
wings. NOTE: Harrows smaller than 30 ft. do not use cables.
n t v Do not move
a n the machine
n n until wings until wings
l l are fully are fully
W W folded. Wing folded. Wing
o
r center
frame damage
u may occur.