Great Plains 2520P Assembly Instructions - Manual (Page 2)

118-870M 4/11/2005
Great Plains Mfg., Inc.
Baffle Package Option 2
Refer to Figure 2
2. Line meter covers with foam seal all the way
around the edges.
Refer to Figure 3
3. Place Seedtube corks (1) in tubes at each end
of the box (2).
Refer to Figure 4
4. Place meter cover over tube outlets not being
used.
5. For the center baffle use a tarp strap to hold in
place by fastening one end to the eyebolt pull-
ing the strap over the baffle and hooking in the
other eye bolt.
6. For the two outside baffles use tarp strap to
hold in place by fastening one end to the eye-
bolt pulling the strap over the baffle and hook-
ing it to the box divider.
NOTE: Shut meters off that are not being used.
Figure 2
Foam Seal
Figure 4
Eye Bolt and Baffle Placement
19253
Plug
Plug
Seed
2520P Rear of Drill
20331
Seed Seed Seed
Baffle covers
two tubes
Baffle covers
two tubes
Baffle covers
two tubes
Eye
Bolt
Eye
Bolt Eye
Bolt
Eye
Bolt
Strap Strap Strap
Note: This drawing refers to the in-
stallation of baffles and seedtube
corks for the left hand side of the drill.
Installation for the right hand side will
be the same.
Figure 3
Foam Seal
20399