Great Plains 3PYP-1630 16-Row 30-Inch Quick Start User Manual
Page 4
Quick Setup Guide for IntelliAg Model 3PYP 16 Row Single Row
11001-1468C-201209
©2012 DICKEY-john Corporation
Specifi cations subject to change without notice.
STEP 12: 5 Revolution Test
Press the Control Setup button
.
Press the Channel Setup button
.
Press the Next Page button
.
Ensure implement is raised before starting 5 Rev Test.
With brakes locked and transmission in PARK position, start tractor engine.
Engage hydraulics and run engine at normal speed until hydraulic fl uid is at operating
temperature.
Press the 5 Rev button
.
Test Ground Speed and Row data must be entered to perform test.
Press and hold remote test button to initiate 5 Rev Test.
1.
2.
3.
4.
5.
6.
7.
8.
9.
4
STEP 13: Summary Screen
The Summary screen provides an overview of setup constants for active control channels.
At the Main Work screen, press the Next Page button
.
Press the Summary button
To view specifi c control channel confi gurations, press the respective control channel
box 1-4.
Press inside a yellow highlighted box to open a specifi c screen for editing.
Press the Work Screen button
to return to the Main Work screen.
1.
2.
3.
4.
5.
Summary
Screen
MASTER
Left Center Right Wing Fold Marker Tilt Marker Fold
MASTER
MASTER
CLUTCH
Master
CFM Switch
Planter Section
Controls
Planter Frame
Controls
Priority Assignments:
Priority 1: Wing Fold
Priority 2: Marker Tilt
Priority 3: Marker Fold
STEP 11: Clutch Folding Module Operation
The planter section controls turn the left, center, and right clutch controls on and off.
Hydraulic drive planters have 2 clutches and use left and right only.
The master switch must be in the ON position to activate any planter section. When a
clutch control is ON, a green light will illuminate.
The frame control switches control the wing fold as well as tilt and fold of the markers.
The switches operate on a priority order. When the priority 1 switch is active, any
lower priority switch turned on will NOT operate until the switch that takes higher
priority is turned OFF.
1.
2.
3.