Great Plains 2SF30 Operator Manual - Manual (Page 13)

Great Plains Manufacturing, Inc. Table of Contents Index Important Safety Information 9
2014-01-09 Table of Contents Index 155-015M-A
818-587C
Caution: Read Operator’s Manual
On top face of tongue near hitch;
1 total
36119
818-043C
Notice: Lift Cylinder Operating Instructions
On top face of tongue near hitch;
1 total
818-043C Rev. A
This machine is equipped with rephasing master slave lift cylinders which
may after a period of time get out of time or phase. An indication of
this is when one section is running too low or too high because its lift
cylinder is either overextended or overetracted compared to the other lift
cylinders. To rephase the cylinders, raise the implement completely up and
hold the tractor hydraulic lever on for a few seconds giving the cylinders
time to rephase. This should be done each time the machine is raised out
of the ground. Momentarily reversing the hydraulic lever immediately after
rephasing to allow the cylinders to retract about 1/2” will help to maintain
a level implement.
LIFT CYLINDERS OPERATING INSTRUCTIONS
NOTICE
36119